Stirrup-type Leg Support Holder
General Requirements
The stirrup-type leg support holder is used for fixing and supporting the patient's limbs during surgical treatment. It is clinically applicable to general surgery, obstetrics and gynecology, urology and other departments.
Main Technical Parameters
- The leg holder is mounted on both sides of the operating table with special fixers, compatible with any operating table.
- One-piece molded foot boot, lightweight design, sturdy and stable, easy to clean.
- Floating foot boot design. When adjusting the angle of the leg holder, the foot boot adapts automatically with the flexion angle of the knee joint to prevent knee injury and strain of nerves and soft tissues.
- Angle adjustment with pneumatic assist rod, equipped with scale display for precise adjustment and quantitative reading.
- Vertical adjustment of foot boot support rod, adjustable angle ≥110°.
- Horizontal adjustment of foot boot support rod, horizontal adjustment range ≥38°, foot boot adjustment range 0-320mm with precise scale display. The bottom of the foot boot is marked with diagrams for left/right foot and correct operation instructions.
- Cantilever length: ≥1000mm.
- Foot boot load capacity ≥25KG, no damage or deformation, no sliding of support rod under load.
- When a 5KG load is applied to the popliteal part of the footrest, no rotation occurs.
- Maximum bearable patient weight: 200Kg.
- Special trolley for hanging and storing the stirrup-type leg support holder. The bottom fixing cover is equipped with two-stage concave positioning grooves for storing other instruments.
Configuration
- 1 set of main bracket
- 1 set of foot boots
- 1 set of fixers
- 1 set of sponge lining pads
- 1 trolley
no comments