2 blades (MIL0, MIL1) + 1 children handle
Only for users with professional intubation training
Sterilization must be performed between patients to prevent cross-infection
Inspect equipment status before use. Once the blade is latched onto the handle and lifted to working position, the light source turns on. Always remove the blade after use, otherwise the bulb will stay on and drain the battery.
If the light fails to turn on, check whether the bulb of the fiber tube is fully seated in the middle of the blade hook. For bulb replacement, loosen the hex screw on the base with a 1.5mm hex wrench, pull out the fiber tube to replace the bulb, re-tighten the screw, then install the fiber tube back into the blade hook slot.
Often purchased together, or from the same category.
Recently viewed
You may also be interested in
Language
Currency
no comments